Cisco MGX 8850 Command Reference Manual page 176

addport
Cards on Which This Command Runs
AXSM
Syntax
addport <ifNum> <bay.line> <guaranteedRate> <maxrate> <sctID> <ifType>
[vpi]
For all ports, guaranteedRate must be the same as maxrate.
Note
Syntax Description
ifNum
bay.line
guaranteedRate
maxRate
Cisco MGX 8850 Routing Switch Command Reference
3-16
A logical port (interface) number. Only one logical port is allowed if the line
operates as a UNI or NNI. For the virtual network to network interface (VNNI),
multiple ports can exist on a line. For AXSM, the range 1–60.
Identifies the bay (1 or 2) and the number of the line. The line number is from 1
to the highest numbered line on the back card. For the range of line numbers on
specific AXSM models, see
Guaranteed rate on a port in cells per second. For all interface types (UNI, NNI,
or VNNI), guaranteedRate must be the same as maxrate. The total guaranteed
rates cannot exceed the highest value in the following ranges:
OC48: 50–5651320 cps
OC12: 50–1412830 cps
OC3: 50–353207 cps
T3: 50–96000 cps for PLCP or 104268 cps for ADM
E3: 50–80000 cps
Maximum rate on a logical port in cells/second. For all interface types (UNI,
NNI, or VNNI), guaranteedRate must be the same as maxrate. The total
maximum rates cannot exceed the highest value in the following ranges:
OC48: 50–5651320 cps
OC12: 50–1412830 cps
OC3: 50–353207 cps
T3: 50–96000 cps for PLCP or 104268 cps for ADM
E3: 50–80000 cps
Chapter 3 Equipment and Resource Provisioning
Table 3-1.
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001