Cnfpnportacc - Cisco MGX 8850 Command Reference Manual

Chapter 6 Logical Node, Port, and Signaling Commands

cnfpnportacc

Configure Port Access—associates an ATM filter set with a port.
The cnfpnportacc command lets you associate an ATM filter set with a port (after you create the filter
set with addfltset). You must specify at least one filter set if you use this command.
Cards on Which This Command Runs
PXM45
Syntax
cnfpnportacc <portid> [-in in-filter-name] [-out out-filter-name]
Syntax Description
portid
-in
-out
Related Commands
delpnportacc, addfltset
Attributes
Log: log
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
The portid is the PNNI physical port. The format is [shelf.]slot[:subslot].port[:subport]. See
also PNNI Format, page 6-4.
in-filter-name: the name of the filter set that applies to SETUP messages that arrive at the port.
out-filter-name: the name of the filter set that applies to SETUP messages that leave the port.
State: active Privilege: GROUP1
Cisco MGX 8850 Routing Switch Command Reference
cnfpnportacc
6-33