Dsppnni-Pkttrace - Cisco MGX 8850 Command Reference Manual

Chapter 5 PNNI Commands
Related Commands
cnfpnni-pkttrace
Attributes
Log: nolog
Example
First, configure the following packet trace parameters through cnfpnni-pkttrace:
•
•
•
Next, check the packet trace you have configure by executing dsppnni-pkttrace.
Geneva.7.PXM.a > cnfpnni-pkttrace -tx 17373186
PNNI/tx_packet on port 17373186 at level 56
> 01:00010064
> 02:09f3b801
> 03:81000000
.
.
.
Geneva.7.PXM.a > dsppnni-pkttrace tx 1 -portId 17373186
Node Index :1
Geneva.7.PXM.a >
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
State: active
The direction is transmit.
The node index is 1.
The logical port identifier is 17373186. If you do not have the logical port identifier, use the
dsppnport command to see the logical port number derived from the physical port number.
01010100 000038a0
47009181 00000000
00000000 000038a0
Port id:
Privilege: CISCO_GP
47009181 00000000
309409f3 b8003094
47009181 00000000
17504 Tx Pkt Trace on
Cisco MGX 8850 Routing Switch Command Reference

dsppnni-pkttrace

309409f3 b8003094
09f3b801 38470091
001a531c 2a00001a
5-93