Cisco MGX 8850 Command Reference Manual page 710

dspcons
AXSM Syntax
dspcons
[-conn <conn id>]
[-filt <filter options>]
[-if <intf no>]
[-vpi <vpi filter>]
[-vci <vci filter>]
AXSM Syntax Description
-conn
-filt
-if
vpi
-
vci
-
Related Commands
dspcon, addcon, cnfcon, delcon, dncon, upcon
PXM45 Attributes
Log: no log
AXSM Attributes
Log: no log
Cisco MGX 8850 Routing Switch Command Reference
9-92
The connection ID (conn ID) of the connection to begin the display. The
format of conn ID is:
ifNum.vpi.vci
The range for ifNum is 1–60 for the AXSM.
The VPI has the range 0–4095. The VCI has the range 32–65535.
Unlike on the PXM45, you do not use keywords for this parameter on the
AXSM. You enter only a number on the AXSM CLI to indicate the state. The
display criteria are:
1 ingr—for errors in the ingress direction
2 egr—for errors in the egress direction
3 condn—for connections where the switch has conditioned the connection
4 iffail—for connection on a failed logical interface
5 ccfail
6 mis
7 abit—for connections where an A-bit error has occurred
A particular logical interface for connection display.
The VPI of all the connections that you would like to display.
The VCI of all the connections that you would like to display.
State: active, standby
State: active, standby
Chapter 9
Privilege: ANYUSER
Privilege: GROUP1
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Troubleshooting Commands