Cisco MGX 8850 Command Reference Manual page 371

Chapter 5 PNNI Commands
dsppnni-node
Display PNNI Node
The dsppnni-node command displays the PNNI logical node information on the local switch. If you do
not provide an index number, the output shows all logical nodes on the switch. However, in the current
release, the display always shows only one logical node—with index number 1.
Cards on Which This Command Runs
PXM45
Syntax
dsppnni-node
[node-index]
Syntax Description
node-index
Related Commands
addpnni-node, cnfpnni-node
Attributes
Log: log
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
— display the PNNI node information address and routing information.
The node-index identifies a logical node in relation to other nodes in the
hierarchy. This node index applies locally within the switch.In the current
release, the only local node index is the default of 1, so you do not actually have
to enter it.
Range: 1–10
Default: 1
State: active, standby Privilege: ANYUSER
Cisco MGX 8850 Routing Switch Command Reference
dsppnni-node
5-77