Aesa_Ping - Cisco MGX 8850 Command Reference Manual

aesa_ping

-trace
-data
-timeout
-interval
-pcr
-scr
Related Commands
dsppingatmaddr
Attributes
Log: log
Cisco MGX 8850 Routing Switch Command Reference
5-16
Specifies whether a path trace is enabled during the ping. The trace stops
when the interval specified by -timeout elapses.
yes: A path trace is enabled.
no: No path trace is enabled.
Default: no
Specify whether data packets are sent with the ping. The data packets cease
when the interval specified by -timeout elapses.
yes: The data packets are sent.
no: No data packets are sent.
Default: disable
Specify the connection timeout for ping. Any selected ping options also
terminate when the interval specified by -timeout elapses.
Range: 5–120 seconds
Default: 5 seconds
Specify the interval between successive transmissions.
Range: 5–120 seconds
Default: 5 seconds
Specify the peak cell rate.
Range: 1–100 cells per second
Default: 10
Specify the sustained cell rate.
Range: 1–50 cells per second
Default: 5
State: active Privilege: SUPER_GP
Chapter 5
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
PNNI Commands