Cisco MGX 8850 Command Reference Manual page 365

Chapter 5 PNNI Commands
dsppnni-link-selection
Display PNNI Link Selection
The dsppnni-link-selection command displays the link selection and both the physical and logical
identifiers for that link. Refer to the description of cnfpnni-link-selection for information about the
criteria PNNI uses to choose between two parallel links.
Cards on Which This Command Runs
PXM45
Syntax
dsppnni-link-selection <portid>
Syntax Description
portid
Display Contents
The display shows the following information for each node.
physical port id
link selection
logical port id
Related Commands
dsppnni-link
Attributes
Log: nolog
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
— display the PNNI link setting, physical port identifier, and logical port identifier.
The PNNI physical port identifier. portid is entered and displayed as a 32-bit
string formatted as [shelf.]slot[:subslot].port[:subport]. For more details, see
PNNI Format.
The portid is the PNNI physical port. The format is
[shelf.]slot[:subslot].port[:subport]. See also
The ASCII string displaying the link routing policy.
The PNNI port identifier in the form of a logical number.
Range: 1–2147483648
State: active, standby
PNNI Format, page
Privilege: ANYUSER
Cisco MGX 8850 Routing Switch Command Reference
dsppnni-link-selection
5-5.
5-71