Cisco MGX 8850 Command Reference Manual page 134

loadrev
Table 2-11 Redundant Pair Upgrade From 2.x to 2.y
Firmware
status
Primary
Secondary
Current
After you execute runrev, the PXM45 updates the database records on disk if changes occur (such as
changes to the configuration or network topology). If you revert to the previous version by executing
abortrev, the post-runrev changes are lost. For example, if a switch was added to the network between
runrev and abortrev, the restored database has no record of the topology change.
Version Numbering Conventions
This section describes how to interpret the version number of a firmware image. Commands such as
loadrev and setrev require a version number rather than a filename. Similarly, dspversion shows the
firmware version number rather than the firmware filename. Although the version number derives from
the firmware filename, they are distinctly different.
Firmware Filenames
The FW directory on the hard drive contains firmware files of possibly many revisions. (Each firmware
file has the fw file extension.) The format of a firmware filename is:
cardtype_version-element[_platform].fw
Note that platform is an optional field because it applies to only the PXM45. For example, a firmware
file may have the name "axsm_002.000.000.001.fw." Within this filename, the version-portion is
002.000.000.001. (Note the absence of "mgx.") This version-portion has the following format:
major-release.minor-release.maintenance.patch
The range for each release, maintenance, and patch is 0–255. Note that, as you read left-to-right, each
element is a superset of the element on the right, and the number on the right resets to 0 or 1 when the
element on its left is incremented. For example, if the minor-release number 010 rolls to 011, the
maintenance on its right is reset to 1, so the new version in the example is 002.011.000.000. (Note the
anomaly here is that the maintenance number resets to 1 rather than 0 because of the IOS convention of
starting maintenance numbers at 1.)
Version Numbers
To derive the firmware version number, the firmware filename is altered by removing insignificant
zeroes and being reformatted to include parentheses. The format of a version number is:
Cisco MGX 8850 Routing Switch Command Reference
2-76
Before upgrade
Active Standby
2.x 2.x
2.x 2.x
2.x 2.x
major-release.minor-release(maintenance.patch)phase
After loadrev After runrev
Active Standby Standby
2.x 2.x 2.y
2.y 2.y 2.x
2.x 2.y 2.y
abortrev resets abortrev resets
only standby card. both cards.
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 2 Shelf Management Commands
After commitrev
Active Standby Active
2.y 2.y 2.y
2.x 2.y 2.y
2.y 2.y 2.y