Switchapsln - Cisco MGX 8850 Command Reference Manual

Chapter 3 Equipment and Resource Provisioning

switchapsln

Switch APS Line
Switches the specified working APS line (bay, line) to its protection line.
See the description for the addapsln command for a detailed explanation of Automatic Protection
Switching (APS).
Cards on Which This Command Runs
AXSM
Syntax
switchapsln <bay> <line> <switchOption>
[<serviceSwitch>]
Syntax Description
bay
line
switchOption
service switch
Related Commands
addapsln, cnfapsln, delapsln, dspapsln, dspapslns, dspapsbkplane, clrbecnt, dspbecnt
Attributes
Log: no log
Example
MGX8850.9.AXSM.a > switchapsln 1.1.1 3 1
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
The working bay number to switch.
The working line number to switch.
The method of performing the switch.
1 = clear (returns to working line)
2 = lockout of protection
(locks out the specified APS pair from being switched to protection line)
3 = forced working->protection
(forces a working line to protection line switch unless the protection line is
locked out)
4 = forced protection->working
(forces a protection line to working line switch; 1+1 architecture mode only)
5 = manual working->protection (manual switch)
6 = manual protection->working (manual switch; 1+1 architecture mode only)
When set to 1, this field causes all APS lines to switch to their protected lines.
State: active Privilege: GROUP1
Cisco MGX 8850 Routing Switch Command Reference
switchapsln
3-103