Cnfilmi - Cisco MGX 8850 Command Reference Manual

cnfilmi

cnfilmi
Configure ILMI
The cnfilmi command lets you configure the card-level ILMI for the AXSM. Activating the card-level
ILMI through cnfilmi requires a pre-existing logical port (see addport) and resource partition (see
addrscprtn or addpart). No response appears unless an error occurs.
For network-level ILMI in relation to PNNI, run the PNNI-specific ILMI commands on the PXM45.
Note
Cards on Which This Command Runs
AXSM
Syntax
cnfilmi <ifNum> -id <partitionID> -ilmi <ilmiEnable> -vpi <vpi> -vci <vci> -trap
<ilmiTrapEnable> -s <keepAliveInt> -t <pollingIntervalT491> -k <pollInctFact>
Syntax Description
ifNum
-id
-ilmi
-vpi
-vci
-trap
-s
-t
-k
Related Commands
dspilmi, dspilmis, dspilmicnt, clrilmicnt, dnilmi, upilmi
Attributes
Log: log
Cisco MGX 8850 Routing Switch Command Reference
4-8
Logical port number. On an AXSM, the range is 1–60.
Partition ID in the range 1–5. (See description of addpart or addrscprtn for information
regarding resource partition ID.)
Enable or disable ILMI. 1=enable. 2=disable.
VPI for the ILMI signaling connection. The range is 0–255.
VPI for the ILMI signaling connection. The range is 0–65535.
Enable or disable ILMI trap. 1=enable. 2=disable.
Keep alive interval. The range is 1–65535 seconds.
Polling interval for T491 in the range 0–65535 seconds.
Polling interval K in the range 0–65535 seconds.
State: active Privilege: GROUP1
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 4 ILMI Commands