Cnfoamsegep - Cisco MGX 8850 Command Reference Manual

cnfoamsegep

cnfoamsegep
Configure OAM Segment Endpoint
Define the port as a segment endpoint for F4 and F5 operations administration and maintenance (OAM)
cells. This command does not take effective for existing connections, and only does for newly
established calls. This command can be used regardless of the state of the port.
Command(s) on Which Command Executes
PXM45
Syntax
cnfoamsegep <portid>
[{yes | no}]
Syntax Description
portid
yes
no
Related Commands
dspoamsegep, cnfconsegep, delconsegep
Attributes
Log: log
Cisco MGX 8850 Routing Switch Command Reference
7-30
The portid represents the PNNI physical port and has the format
[shelf.]slot[:subslot].port[:subport]. See also
The port is configured as a segment endpoint and is a segment endpoint for all
connections on this port.
The port is not a segment endpoint.
Default = no
State: active
PNNI Format, page
Privilege: GROUP1
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 7 SPVC and SVC Commands
7-4.