Cisco MGX 8850 Command Reference Manual page 177

Routing switch

Hide thumbs Also See for Cisco MGX 8850:

Table of Contents

Equipment and Resource Provisioning

Related Commands

cnfport, delport, dspport, dspports, dspportsct

Create logical port 1 on line 1, bay 1. Currently, the minimum and maximum cells per second must be

the same and are 96000 cps in this example. The egress SCT file ID is 4. The interface type is NNI (2).

MGX8850.9.AXSM.a > addport 1 1.1 96000 96000 4 2

Release 2.0, Part Number 78-10467-04 Rev C0, October 2001

The ID of a service class template (SCT) for the port. The range is 0–255. The

SCT file must exist on the PXM45 disk. See cnfcdsct.

Cisco Systems provides SCT numbers 2 and 3. You can create more SCTs by

modifying an existing SCT through the Cisco WAN Manager application and

saving it with another SCT number. Subsequently, you can assign the new SCT

to the port by the sctID parameter in cnfport.

Currently, the system does not support certain parameters in the

SCTs, so you can specify them through addcon, cnfcon, or Cisco

WAN Manager. These parameters are PCR, SCR, and ICR.

Specifies the interface type:

3 = Virtual path NNI (VNNI)

Virtual path identifier in the range 1–4095.

State: active

Privilege: GROUP1

Cisco MGX 8850 Routing Switch Command Reference

Chapters

Table of Contents