Cnfaddrreg - Cisco MGX 8850 Command Reference Manual

cnfaddrreg

cnfaddrreg
Configure Address Registration
This command lets you enable or disable ILMI address registration for a port. Before you can run
cnfaddrreg, the following must have occurred:
1.
2.
The cnfaddrreg command can also enable (or disable) the address registration for backward
compatibility.
The peer must support address registration, so you must confirm that address registration is enabled on
all three places.
Cards on Which This Command Runs
PXM45
Syntax
cnfaddrreg <portid> [{yes | no}]
Syntax Description
In addition to typing a port ID, you must also type either "yes" or "no." The default is "yes."
portid
yes
no
Related Commands
None
Attributes
Log: log
Examples
Disable ILMI address registration on port 4:1.1:11.
Geneva.7.PXM45.a > cnfaddrreg 4:1.1:1 no
Cisco MGX 8850 Routing Switch Command Reference
4-6
The applicable port must have been created by running the addpnport command.
The port must be downed by running the dnpnport command.
The portid is the PNNI physical port. The format is [shelf.]slot[:subslot].port[:subport].
See also PNNI Format, page
Enable ILMI address registration on the port. The default is "yes" (enabled).
Disable ILMI address registration on the port.
State: active
4-2.
Privilege: GROUP1
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 4 ILMI Commands