Timeout - Cisco MGX 8850 Command Reference Manual

timeout

timeout
Timeout—specifies the number of seconds of idle time for the current user-session.
The timeout command lets you extend the amount of idle time in a user-session from the default of
10 minutes. If you do not specify a timeout period, the system displays the current timeout. At the end
of the session, the system logs you out.
To disable the session timeout function, specify 0 seconds.
Note The timeout command is the same as the sesntimeout command.
Cards on Which This Command Runs
PXM45, AXSM
Syntax
timeout
[time_out]
Syntax Description
time_out
Related Commands
sesntimeout
Attributes
Log: no log
Examples
Display the current timeout.
pinnacle.7.PXM.a > timeout
The timeout period for this session is currently 600 second(s)
pinnacle.7.PXM.a >
Set the session timeout threshold to 100 minutes (6000 seconds).
pinnacle.7.PXM.a > timeout 6000
The timeout period for this session is now set to 5000 second(s)
pinnacle.7.PXM.a >
Cisco MGX 8850 Routing Switch Command Reference
2-100
Number of idle seconds time allowed for the session.
State: active, standby, init
Chapter 2 Shelf Management Commands
Privilege: ANYUSER
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001