Cisco MGX 8850 Command Reference Manual page 393

Chapter 5 PNNI Commands
remote node id
remote port id
local port id
aggregation token
Uplink IG Parameters
type
length
flags
remote higher level node id
common pg id
local port id
aggregation token
upnode ATM address
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
The node ID of the remote node. For a description of the node ID,
see the description for addpnni-node or cnfpnni-node.
The logical PNNI identifier on the remote interface. For more
details, see
Range: 1–2147483648
The logical PNNI identifier on the local interface. For more details,
see PNNI
Range: 1–2147483648
See the description of the cnfpnni-intf command for a definition of
an aggregation token. The current release does not support link
aggregation.
Range: 1–32
The current release does not support uplinks.
Note
The ASCII string that indicates the type of up link IG parameters.
A 16-bit number.
A string of 8-bit flags.
The PNNI node identifier assigned to a PNNI node.
The peer group ID (of length level) that assigned to the PNNI
common PG. This peer group is the local peer group.
Default: Figure 5-1 shows the factory-set default.
The logical PNNI identifier on the interface. For more details, see
PNNI
Range: 1–2147483648
Range: 1–2147483648.
The ATM address of the PNNI uplink node. The upnode ATM
address is a 20-byte, hexadecimal string. The upnode is the node at
the other end of the uplink. It is the neighboring peer of the ancestor
of the node from which the uplink originates.
Default: none
PNNI Format.
Format.
Format.
Cisco MGX 8850 Routing Switch Command Reference
dsppnni-ptse
5-99