Delpart - Cisco MGX 8850 Command Reference Manual

Chapter 3 Equipment and Resource Provisioning

delpart

Delete Resource Partition
Delete a resource partition. Note that you must delete all connections in the resource partition before you
can delete it. For information on resource partitions, refer to the description of addpart.
Note The delpart and delrscprtn commands are identical. The name 'delrscprtn' is consistent with the
corresponding command in Release 1 of the MGX 8850 switch. You can use either command.
Cards on Which This Command Runs
AXSM
Syntax
delpart <if_num> <part_id>
Syntax Description
if_num
part_id
Related Commands
addpart, cnfpart, dsppart
Attributes
Log: log
Example
MGX8850.1.9.AXSM.a > delpart 1 1
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Logical interface (port) number. For AXSM, the range is 1–60.
The partition ID number in the range 1–5. Use dspparts (or dsprscprtns) to see all
resource partitions if necessary.
State: active Privilege: GROUP1
Cisco MGX 8850 Routing Switch Command Reference
delpart
3-41