Uppnport - Cisco MGX 8850 Command Reference Manual

Chapter 6 Logical Node, Port, and Signaling Commands

uppnport

Up PNNI Port:
The uppnport command lets you put a UNI or NNI port into service (administratively "up" the port).
The circumstances in which you would use the uppnport command are as follows:
•
•
Cards on Which This Command Runs
PXM45
Syntax
uppnport <portid>
Syntax Description
portid
Related Commands
addpnport, delpnport, dnpnport, dsppnport, dsppnports
Attributes
Log: log
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
After you have downed the port for any reason by using the dnpnport command
After you have pre-configured a port by using the addpnport command (see taddpnport
description)
The portid is the PNNI physical port. The format is [shelf.]slot[:subslot].port[:subport].
See also PNNI Format, page
State: active
6-4.
Privilege: GROUP1
Cisco MGX 8850 Routing Switch Command Reference
uppnport
6-117