Cnfserialif - Cisco MGX 8850 Command Reference Manual

Chapter 2 Shelf Management Commands

cnfserialif

Configure Serial Interface
The cnfserialif command lets you change the data rate on a serial interface on the PXM45-UI-S3 back
card. The two types of serial ports are the console port and the maintenance port. These ports provide
user-access for controlling the switch. The default speed n a serial interface is 9600 bits per second, but
higher speed terminals are frequently available.
Each port connects to a different type of terminal implementation. Refer to the Cisco MGX 8850 Routing
Switch Software Configuration Guide for a description of how to use these physical ports for switch
control.
Cards on Which This Command Executes
PXM45
Syntax
cnfserialif <port#> <speed>
Syntax Description
port#
speed
Related Commands
delserialif, dspserialif
Attributes
Log: no log
Example
Configure the console port to have a data rate of 19200 bits per second.
node19.8.PXM.a > cnfserialif 2 19200
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Specifies the physical port:
1=maintenance port.
•
2=console port.
•
Specifies a data rate in bits per second. Valid entries are 1200, 2400, 4800, 9600,
19200, and 38400.
State: active Privilege: SUPER_GP
Cisco MGX 8850 Routing Switch Command Reference
cnfserialif
2-31