Cisco MGX 8850 Command Reference Manual page 333

Chapter 5 PNNI Commands
cnfpnni-scope-map
Configure PNNI Scope Map Table
The cnfpnni-scope-map command specifies how UNI 4.0 address scope values are mapped to PNNI
hierarchal levels. These parameters are stored in the scope map table.
Note This function requires support of UNI 4.0 and therefore is not supported in this release.
Cards on Which This Command Runs
PXM45
Syntax
cnfpnni-scope-map <scope> <level>
Syntax Description
scope
level
Related Commands
dsppnni-scope-map
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
— specify the table that maps the UNI 4.0 values to the PNNI hierarchy levels.
Specify the UNI 4.0 address scope.
Range: 1–15, where:
1 = LocalNetwork
2 = LocalNetworkPlusOne
3 = LocalNetworkPlusTwo
4 = SiteMinusOne
5 = IntraSite
6 = SitePlusOne
7 = OrganizationMinusOne
8 = IntraOrganization
9 = OrganizationPlusOne
10 = CommunityMinusOne
11 = IntraCommunity
12 = CommunityPlusOne
13 = Regional
14 = InterRegional
15 = Global
Default: none
Specify the PNNI level to which the UNI 4.0 address scope is mapped.
Range: 1–104
Default: 56
Cisco MGX 8850 Routing Switch Command Reference
cnfpnni-scope-map
5-39