Cisco MGX 8850 Command Reference Manual page 311

Chapter 5 PNNI Commands
Example
This example shows the aesa_ping command line that pings the ATM end station with the address
47.00918100000000d058ac23ac.00d058ac23ac.01. The ping is configured as follows:
•
•
•
•
•
•
•
•
SanJose.7.PXM.a > aesa_ping 47.00918100000000d058ac23ac.00d058ac23ac.01 -setupcall no
-qos ubr -trace no -data disable -timeout 6 -interval 60 -pcr 5 -scr 5
Ping Got CLI message, index=0
PING:from PNNI—SOURCE ROUTE
DTL
DTL 1:NODE 1::56:160:71:0:145::238:238:238:238:Port 1:262656
DTL 1:NODE 2::56:160:71:0:145::88:172:35:172:Port 2:0
Port List :no of ports =
Port ID
SanJose.7.PXM.a >
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
No call is set up.
The QoS metric is UBR.
No trace is enabled.
No data is sent with the ping.
The ping waits six seconds for a reply.
The ping re-occurs every 60 seconds unless it finishes.
The peak cell rate of the ping is five cells per second (cps).
The sustained cell rate of the ping is five cps.
1 :Number of (Node/port)elements
1:262656
2
1
Cisco MGX 8850 Routing Switch Command Reference
aesa_ping
5-17