Cisco MGX 8850 Command Reference Manual page 324

cnfpnni-node
-complexNode
-branchingRestricted
In the current release, you must keep the default values for -lowest, -complexNode, and
Note
-branchingRestricted.
Cisco factory-set defaults for address prefixes and the peer group ID share field values with the ATM
Caution
address. If you change the peer group ID, you should change the corresponding fields in the ATM
address and node identifier. (See
Cisco MGX 8850 Routing Switch Command Reference
5-30
Specify whether this node is a complex node. The lowest-level node cannot
be a complex node.
on: This node is a complex node.
off: This node is not a complex node.
Default: off
This release does not support multiple peer groups, so this
Note
parameter must remain off.
Specify whether the PNNI node allows point-to-multipoint branches.
on: This node does not allow point-to-multipoint branches.
off: This node allows point-to-multipoint branches.
Default: on
This release does not support branching, so this parameter must
Note
remain on.
Figure 5-6 for the mapping between these addresses.)
Chapter 5
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
PNNI Commands