Cisco MGX 8850 Command Reference Manual page 547

Chapter 7 SPVC and SVC Commands
-cdvt
-lcdv
-rcdv
-cc
-stat
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Local Cell Delay Variation Tolerance (CDVT). Specifies the CDVT from a local
endpoint to a remote endpoint (1–5000000 microseconds). Cell Delay Variation
Tolerance controls the time scale over which the PCR is policed.
Note that no remote CDVT is necessary.
Local Cell Delay Variation (CDV). Specifies the CDV from a local endpoint to
a remote endpoint (1–16777215 microseconds). Cell Delay Variation is the peak
to peak cell delay variation expressed in microseconds.
Remote Cell Delay Variation (CDV). Specifies the CDV from a remote endpoint
to a local endpoint (1–16777215 microseconds). Cell Delay Variation is the peak
to peak cell delay variation expressed in microseconds.
Operations, administration, and maintenance continuity check (OAM CC): enter
1 to enable or 0 to disable. The default is 0.
To provision continuity checking, you must enable this function at both ends of
the connection, otherwise a connection alarm results. Therefore, even as you
create the connection with this parameter, the connection goes into alarm until
both ends of the connection are up.
Statistics collection: enter 1 to enable or 0 to disable. The default is 0.
The Cisco WAN Manager tool collects statistics for a connection if you enable
it here. Statistics collection is disabled for all connections by default. Statistics
collection has an impact (which may not be significant) on the real-time
response, especially for SVCs (which can be affected even though you do not
add SVCs). Therefore, you should enable statistics collection for only the subset
of connections that really warrants such a feature.
Cisco MGX 8850 Routing Switch Command Reference
addcon
7-11