Dsprteoptcnf - Cisco MGX 8850 Command Reference Manual

Chapter 8 Network Optimization Commands

dsprteoptcnf

Display Route Optimization Configuration
Display the current configuration for route optimization. The configuration itself originates with the
cnfrteopt command. The dsprteoptcnf display shows the following:
•
•
•
•
•
Cards on Which Command Executes
PXM45
Syntax
dsprteoptcnf
Syntax Description
This command takes no parameters.
Related Commands
cnfrteopt, opte, dsprteoptstat, cnfrteoptthld
Attributes
Log: no log
Example
Display the current route optimization for the switch. No optimization has been configured on any ports.
pop20two.7.PXM.a > dsprteoptcnf
Configuration of Route Optimization:
Percentage Reduction Threshold: 30
Port
1:2.1:2
1:2.2:3
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
The node-level threshold for route optimization. It is the percent of reduction in the route cost.
Identity of the optimization target by port and VPI/VCI range.
Enable status of optimization.
Interval between times that optimization begins.
Start and stop times for route optimization.
State: active, standby
Enable VPI/VCI Range
no
no
Privilege: ANYUSER
Interval Time Range
Cisco MGX 8850 Routing Switch Command Reference
dsprteoptcnf
8-17