Cisco MGX 8850 Command Reference Manual page 344

dbgpnni
Example
Specify the following PNNI debug message-options:
•
•
Use dsppnni-dbg to check which debug messages types appear on the terminal.
SanJose.7.PXM.a > dsppnni-dbg
pnni debugging option:
hello
-----
off
address
-------
off
SanJose.7.PXM.a > dbgpnni -itf on -address on
SanJose.7.PXM.a > dsppnni-dbg
pnni debugging option:
hello
-----
off
address
-------
on
In the second example, the parameters are changed as follows:
•
•
SanJose.7.PXM.a > dbgpnni -itf off -address off
SanJose.7.PXM.a > dsppnni-dbg
pnni debugging option:
hello
-----
off
address
-------
off
SanJose.7.PXM.a >
Cisco MGX 8850 Routing Switch Command Reference
5-50
Interface debugging is enabled.
Address handling debugging is enabled.
election nbr itf
-------- --- ---
off off off
itdb ra cp
---- --- ---
off off off
election nbr itf
-------- --- ---
off off on
itdb ra cp
---- --- ---
off off off
Interface debugging is disabled.
Address handling debugging is disabled.
election nbr itf
-------- --- ---
off off off
itdb ra cp
---- --- ---
off off off
timer lgn spt node reachability
----- --- --- -----------------
off off off off
link selection
--------------
off
timer lgn spt node reachability
----- --- --- -----------------
off off off off
link selection
--------------
off
timer lgn spt node reachability
----- --- --- -----------------
off off off
link selection
--------------
off
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 5
off
PNNI Commands