Cnfuser - Cisco MGX 8850 Command Reference Manual

Chapter 2 Shelf Management Commands

cnfuser

Configure User
Configure a new password or privilege level for a user. If the user does not already exist, executing
cnfuser with a new user-name creates that user.
If you do not specify a user-name (userID) but include one or more of the other parameters, the command
applies to the current user.
Cards on Which This Command Runs
PXM45
Syntax
cnfuser
-u <userID>
[-p <password>]
[-l <accessLevel>]
[-i <expiration interval>]
Syntax Description
-u
-p
-l
-i
Related Commands
adduser, deluser, dspusers, cnfpswdexpire, dsppswdexpire
Attributes
Log: no log
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Keyword that specifies a string of 1–12 characters that identifies a user. The maximum
number of users a system can accept is 50.
(Optional) Keyword that specifies a new password with 5–15 characters for userId.
(Optional) Keyword that specifies a new access level for the user. The accessLevel can be
SERVICE_GP, SUPER_GP, GROUP1, or ANYUSER. The new level you type must be
lower than the privilege of the current user. See adduser description for an explanation of
privilege levels.
(Optional) Keyword that specifies the password expiration interval. The password
expiration interval is the number of days that a password is valid. At the end of those days,
the user must change the password. The range for the expiration interval is 1–1000 days.
(See cnfpswdexpire and dsppswdexpire).
State: active Privilege: GROUP1
Cisco MGX 8850 Routing Switch Command Reference
cnfuser
2-37