Cisco MGX 8850 Command Reference Manual page 98

commitrev
Of special note in
Note
new version of firmware. The reversed location of the "Active" and "Standby" columns shows these
changed states.
Table 2-8
Firmware
status
Primary
Secondary
Current
Cards on Which This Command Runs
PXM45
Syntax
commitrev <slot> <revision>
Syntax Description
slot
revision
Related Commands
loadrev, abortrev, runrev, setrev, dspversion
Attributes
Log: log
Example
Commit the PXM45 in slot 8 to the graceful upgrade to file pxm45_002.000.000.000_mgx.fw (so 2.0(0)
is the version). The system prompts you to confirm that you want the command to execute.
pinnacle.8.PXM.a > commitrev 8 2.0(0)
Cisco MGX 8850 Routing Switch Command Reference
2-40
Table 2-8, runrev causes the standby card to become the active card and run the
Redundant Pair Upgrade From 2.x to 2.y
Before upgrade After loadrev
Active Standby Active
2.x 2.x 2.x
2.x 2.x 2.y
2.x 2.x 2.x
abortrev resets the
standby card.
Number of the slot where firmware must revert to previous version.
Revision number derived from the name of the firmware file. For an explanation, see
the section, "Version Numbering
State: active
Chapter 2
After runrev
Standby Standby Active
2.x 2.y 2.y
2.y 2.x 2.x
2.y 2.y 2.y
abortrev resets
both cards.
Conventions," in the loadrev description.
Privilege: SERVICE_GP
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Shelf Management Commands
After commitrev
Standby Active
2.y 2.y
2.y 2.y
2.y 2.y