Dspconsegep - Cisco MGX 8850 Command Reference Manual

dspconsegep

dspconsegep
Display Connection Segment Endpoint
Displays OAM segment endpoint for a connection endpoint. When both VPI and VCI are present, the
segment endpoint is an F5 flow endpoint (for VCCs). When the optional VCI is not present, the segment
endpoint is an F4 flow endpoint (for VPCs). This command is used only for established calls.
The delconsegep command works for SVCs only.
Note
Cards on Which This Command Runs
PXM45
Syntax
dspconsegep <portid>
vpi
[vci]
Syntax Description
portid
vpi
vci
Related Commands
cnfoamsegep, dspoamsegep, cnfconsegep, delconsegep
Attributes
Log: log
Cisco MGX 8850 Routing Switch Command Reference
7-46
The portid represents the PNNI physical port and has the format
[shelf.]slot[:subslot].port[:subport]. See also
The VPI of the connection.
The VCI of the connection.
State: active, standby
PNNI Format, page
Privilege: ANYUSER
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 7 SPVC and SVC Commands
7-4.