Cnfsnmp - Cisco MGX 8850 Command Reference Manual

cnfsnmp

cnfsnmp
Configure SNMP Strings
Configure the SNMP strings. The three strings are community, contact, and system location. You can
configure only one of these strings with a single execution of cnfsnmp.
Cards on Which This Command Executes
PXM45
Syntax
cnfsnmp
-community [string <ro | rw>]
-contact [string]
-location [string]
Syntax Description
-community
-contact
-location
Attributes
Log: log
Related Commands
dspsnmp
Cisco MGX 8850 Routing Switch Command Reference
2-32
Keyword that establishes the community access string to permit access to SNMPv1
protocol.
The string acts like a password and permits access to the SNMP Protocol. Further, the
access of either read-only or read-write allows operations on MIB Objects according
to the setting. The setting can be either "ro" for read-only or "rw" for read-write. The
default is read-only With read-only, authorized management stations are only able to
retrieve MIB objects.
With read-write access, authorized management stations are able to retrieve and
modify MIB objects.
Keyword that specifies the system contact string for sysContact MIB object in
MIB-II. The string in this case is text that describes the contact. For example, the
contact could be an administrator's email address. The default is no text.
Keyword that specifies the location of the system. The default is no text. The system
location string is used for sysLocation MIB object in MIB-II.
State: active
Chapter 2
Privilege: SUPER_GP
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Shelf Management Commands