Cisco MGX 8850 Command Reference Manual page 129

Chapter 2 Shelf Management Commands
Pre-release, developmental versions have one or two alphanumeric characters at the end of the version
number, and these versions may appear in various contexts. For example, the help display for setrev
gives examples of revision, but only the first two in the following list could be in released product. These
two bullets show major release 2, minor release 1, and the minimal maintenance number of 1. The last
three bullets show developmental revision numbers:
•
•
•
•
•
Cards on Which This Command Executes
PXM45, AXSM
Syntax
dspversion
Syntax Description
This command takes no parameters.
Related Commands
abortrev, commitrev, loadrev, runrev, setrev, dspcd
Attributes
Log: no log
Example
Display the firmware version for the current PXM45.
pop20two.7.PXM.a > dspversion
Image Type
----------
Display firmware image on the AXSM in slot 1. As the example shows, the command executes on the
CLI of the AXSM after you have switched (cc) to that CLI.
Unknown.1.AXSM.a > dspversion
Image Type
----------
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
2.0(1) Note the absence of a patch number.
2.0(1.248) Note the patch number is 248.
2.0(0.1)A1 Note the phase number is A1.
2.0(0.10)D2 Note the phase number is D2.
2.0(0.248)P1, 2.0(0.1)P2, 2.0(0.113)P3, 2.0(0.10)P4
State: active, standby, init
Shelf Type
----------
Runtime MGX
Boot MGX
Shelf Type
----------
Runtime MGX
Boot MGX
Privilege: ANYUSER
Card Type Version
---------- ------------
PXM45 2.0(0.30)P2
PXM45 2.0(0.30)P1
Card Type Version
---------- ------------
AXSM 2.0(0.30)P2
AXSM 2.0(0.15)A
Cisco MGX 8850 Routing Switch Command Reference
Built On
------------
Jan 17 2001, 16:43:13
-
Built On
------------
Jan 17 2001, 17:06:31
-
dspversion
2-71