Cisco MGX 8850 Command Reference Manual page 167

Chapter 3 Equipment and Resource Provisioning
APS 1:1 is only supported on Model B software. It is not supported on Model A software.
Note
3
Cards on Which This Command Runs
AXSM
AXSM Syntax
addapsln <workingIndex> <protectIndex> <archmode>
AXSM Syntax Description
workingIndex
protectIndex
archmode
Related Commands
cnfapsln, delapsln, dspapsln, dspapslns, switchapsln, dspapsbkplane, clrbecnt, dspbecnt
Attributes
Log: log
Example
The following example assigns 1+1 APS redundancy to two lines on the same card:
MGX8850.9.AXSM.a > addapsln 9.2.1 9.2.2 1
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Slot number, bay number, and line number of the working line in the format:
slot.bay.line
Slot number, bay number, and line number of the protection line in the format:
slot.bay.line
The APS architecture mode to be used on the working/protection line pairs.
1 = 1+1 – provides line redundancy with traffic on both lines.
•
2 = 1:1 – provides line redundancy with traffic on the active line only.
•
State: active Privilege: GROUP1
Cisco MGX 8850 Routing Switch Command Reference
addapsln
3-7