Cisco MGX 8850 Command Reference Manual page 390

dsppnni-ptse
PTSE ID
PTSE type
Nodal State Parameter Information
internal reachable ATM
addresses
exterior reachable ATM
addresses
PTSE length
sequence
checksum
remaining lifetime
details for IG
Nodal Information Group Parameters
type
length
ATM address
priority
nodal flags
preferred PGL
next higher level binding
information IG type
Cisco MGX 8850 Routing Switch Command Reference
5-96
The unique identifier of the PTSE. ptse-id is a 32 bit number index
assigned by the PNNI node that created the PTSE.
The type of PTSE is an ASCII designated by the ATM forum PNNI
standard. Broad and narrow categories.
A list of reachable ATM addresses that are inside the peer group or
network.
A list of reachable ATM addresses that are outside the network. The
current release does not support exterior addresses.
The number of bytes in the PTSE—a 16-bit number.
The sequence of the PTSE—a 32-bit number.
The checksum error-checking value. A 16-bit hex number.
The length of the remaining lifetime (in seconds). 32-bit number.
The flag that determines the level of details for information group
(IG) if the detail option is enabled ("true").
The current release does not support the logical group node (LGN), preferred
Note
peer group leader (PGL), and other items that pertain to the levels of a
multi-peer group.
The type of nodal information group (IG).
The length of the nodal IG PTSE. A 16-bit number.
The upnode ATM address is a 20-byte, hexadecimal string. The
upnode is the node at the other end of the uplink. It is the
neighboring peer of the ancestor of the node from which the uplink
originates.
The value of the priority parameter, an 8-bit number.
The 8-bit nodal flags.
A 22-byte hex string. The current release does not support peer
group leader (PGL).
The next higher level binding information IG type is an ASCII
string. The current release does not support higher level binding.
Chapter 5
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
PNNI Commands