Cnfilmiproto - Cisco MGX 8850 Command Reference Manual

cnfilmiproto

cnfilmiproto
Configure ILMI Protocol
The cnfilmiproto command lets you configure how PNNI reacts to ILMI slave events. Use dsppnilmi
to confirm changes to the prefix
Cards on Which This Command Runs
PXM45
Syntax
cnfilmiproto <portid> [-securelink {yes|no}] [-attachmentpoint {yes |
[-modlocalattrstd {yes | no]
Syntax Description
portid
-securelink
-attachmentpoint Sets the flag attachmentpoint to make PNNI release the call if the slave ILMI
-modlocalattrstd
Related Commands
dsppnilmi
Attributes
Log: log
Cisco MGX 8850 Routing Switch Command Reference
4-12
.
The portid is the PNNI physical port. The format is
[shelf.]slot[:subslot].port[:subport]. See also
Sets the flag securelink to make PNNI release the call if it loses connection to the
ILMI slave.
no: do not enable the ILMI Secure link protocol.
yes: disable the ILMI Secure link protocol.
Default: yes
session sees changes in peer information, such as the system name or system ID.
no: do not enable the detection of loss of attachmentpoint protocol.
yes: Enable the detection of loss of attachmentpoint.
Default: yes
Sets the flag modlocalattrstd to make PNNI release the call if the slave ILMI sees
ATM layer (partition resource) changes, such as the VPI or VCI.
no: disable the ILMI standard procedure for modification of local ATM param.
yes: enable the ILMI standard procedure for modification of local ATM param.
Default: yes
State: active
PNNI Format, page
Privilege: GROUP1
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 4 ILMI Commands
no]
4-2.