Dspload - Cisco MGX 8850 Command Reference Manual

dspload

dspload
Display Load—displays maximum channels and bandwidth and currently available channels and bandwidth on a
partition.
This command displays the configured maximum and guaratneed number of channels and the configured
maximum and guaranteed bandwidth on a partition on a logical interface. It also displays the currently
available number of channels and the currently available bandwidth on the partition.
This information can allow you to determine the throughput requirements for a partition and the actual
resource utilization.
The output shows the configured bandwidth for user connections of all service classes.
The display also shows the load created by control VCs. The control VCs are of three types: SSCOP,
PNNI-RCC, and ILMI (if ILMI is enabled). The bandwidth allocations for SSCOP and PNNI-RCC
control VCs are configurable (see cnfpnctlvc.) The bandwidth for an ILMI VC is fixed, as follows:
PCR=1000 cps; SCR=50cps; and MBS=1024 cells.
Cards on Which This Command Runs
AXSM
Syntax
dspload <ifNum> <partId>
Syntax Description
ifNum
partId
Related Commands
dsprscprtn, addcon, dspcons, dspcon, cnfcon
Attributes
Log: no log
Cisco MGX 8850 Routing Switch Command Reference
8-12
The logical port number. The range for AXSM is 1–60.
The partition identifier. The range is 1–20. If necessary, use dsprscprtns to see the
existing partitions.
State: active, standby
Chapter 8
Privilege: ANYUSER
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Network Optimization Commands