Cisco MGX 8850 Command Reference Manual page 549

Chapter 7 SPVC and SVC Commands
Error Messages
The system can display error messages for the following reasons:
•
•
•
•
One of the following error messages appears if one of the preceding causes is true:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Related Commands
cnfcon, cnfabr, delcon, dspcon, dspcons, dncon, upcon
Attributes
Log: log
Example
Add the slave end of a VCC on logical port 1 with VPI=10, VCI=40, CBR service type. Note that the
system returns the slave end connection identifier in the hexadecimal NSAP format with the VPI.VCI at
the end. When you add the master endpoint of the connection, type –slave followed by this connection
identifier. You can do a copy and paste rather than typing the whole string.
MGX8850.AXSM.a >addcon 1 10 40 1 s
slave endpoint added successfully
slave endpoint id: 00000E1000001C008051B730FFFFFF010B180100.10.40
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Some of the traffic management parameters apply to specific service types (rt-VBR, for example).
If you type a parameter that does not apply to a selected traffic type, the connection is rejected.
Insufficient resources are available to accept the provisioning request.
The type of card does not support a certain feature.
The port cannot support SPVCs.
"Port does not support requested serviceType"
"lscr/lmcr not allowed to exceed lpcr (dcmp)"
"rscr not allowed to exceed rpcr"
"lpcr must be defined for cbr serviceType"
"rpcr must be defined for cbr serviceType"
"lpcr and lscr must be defined for vbr serviceType"
"rpcr and rscr must be defined for vbr serviceType"
"lpcr must be defined for abr/ubr serviceType"
"rpcr must be defined for abr/ubr serviceType"
"Requested rcdv is too low"
"Requested rctd is too low"
"Requested max cell loss ratio (clr) is too high"
"Requested cell rate (lscr/lpcr) is too high"
"Requested cell rate (rscr/rpcr) is too high"
State: active Privilege: GROUP1
Cisco MGX 8850 Routing Switch Command Reference
addcon
7-13