Dsppart - Cisco MGX 8850 Command Reference Manual

Chapter 3 Equipment and Resource Provisioning

dsppart

Display Resource Partition
Displays information about one resource partition. The displayed information is shown in the example.
Note The dsppart and dsprscprtn commands are identical. The name 'dsprscprtn' is consistent with the
corresponding command in Release 1 of the MGX 8850 switch. You can use either command.
Note The connection count includes control VCs when you execute dsppart on the CLI of a service
module. However, when you execute dspcd or dsppnport(s) on the CLI of the controller card, the
display does not include control VCs.
The total number of connections in the display includes control VCs. The types of control VCs are
SSCOP, PNNI-RCC, and ILMI (if ILMI is enabled). To see the connection counts that do not include
control VCs, use dsppnport.
Cards on Which This Command Runs
AXSM
Syntax
dsppart <ifNum> <partId>
Syntax Description
if_num
part_id
Related Commands
addpart, cnfpart, delpart, dspparts
Attributes
Log: no log
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Logical interface (port) number. For AXSM, the range is 1–60.
Partition identifier in the range 1–5.
State: active, standby Privilege: ANYUSER
Cisco MGX 8850 Routing Switch Command Reference
dsppart
3-81