Dspsct - Cisco MGX 8850 Command Reference Manual

dspsct

dspsct
Display SCT
Display the contents of a service class template (SCT) for either the egress or ingress direction. For
information on SCTs, see the cnfcdsct and addport description. Also, refer to the description of SCTs
in the Cisco MGX 8850 Switch Software Configuration Guide, Release 2.
With the dspsct command, you can specify:
•
•
•
Note
Cards on Which This Command Runs
AXSM
AXSM Syntax
dspsct <SCT_section> <sctID> <egr | ing>
AXSM Syntax Description
SCT_section
sctID
egr | ing
Related Commands
cnfcdsct, dspcdsct
Cisco MGX 8850 Routing Switch Command Reference
3-98
Egress or ingress direction
A particular SCT template
A section within the SCT (see Syntax Description for an explanation)
Currently, the system does not support certain parameters in the service class templates
(SCTs), so you can specify them through addcon, cnfcon, or Cisco WAN Manager.
These parameters are (when applicable) PCR, SCR, and ICR.
A specific part of the SCT, as follows:
• bw for bandwidth
• gen for policing and CAC
• cosb
• vcThr for VC thresholds
• cosThr for COSB thresholds
SCT identifier in the range 1–255.
Specifies the direction to which the template applies. Enter the entire string "eng" or
"ing."
Chapter 3 Equipment and Resource Provisioning
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001