Cisco MGX 8850 Command Reference Manual page 431

Chapter 6 Logical Node, Port, and Signaling Commands
Example
Add a port with the ID 6:1.1:1. Use the dsppnports command to see if 6:1.1:1 appears in a list of all
ports.(If many PNNI ports already existed, you could use the dsppnport command for 6:1.1:1) It
appears at the end of the list—after the entries for BITS clock ports in the format 7.x.
Note that the IF status and the Administrative status are both up. (The IF refers to the logical interface
on the service module—the slave side rather than the PNNI controller side.) That IF status and the
Administrative status are up indicates that the addpart and addport commands have already been used
on the service module. If these commands had not been executed, IF and Admin would be "provisioning"
and "down," respectively. For details on the content of the dsppnports command, see its description.
M8850_NY.7.PXM.a > addpnport 6:1.1:1
M8850_NY.7.PXM.a > dsppnports
Summary of total connections
(p2p=point to point,p2mp=point to multipoint,SpvcD=DAX spvc,SpvcR=Routed spvc)
Type
p2p:
p2mp:
Summary of total configured SPVC endpoints
Type
p2p:
p2mp:
Per-port status summary
PortId
7.35
7.36
7.37
7.38
1:2.1:1
2:2.2:1
3:1.1:1
3:1.2:2
6:1.1:1
M8850_NY.7.PXM.a >
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
#Svcc: #Svpc: #SpvcD:
0 0 0
0 0 0
Total=
#SpvcR #SpvpR #SpvcD
0 0 2
0 0 0
Total=2
LogicalId IF status
17251107 up
17251108 up
17251109 up
17251110 up
16848897 up
16914433 provisioning
16979969 down
0 provisioning
17176577 up
#SpvpD: #SpvcR: #SpvpR:
0 0 0
0 0 0
0/50000
#SpvpD Total
0 2
0 0
Admin status ILMI state
up NotApplicable
up NotApplicable
up NotApplicable
up NotApplicable
up UpAndNormal
up NotApplicable
up Disable
down NotApplicable
up Disable
Cisco MGX 8850 Routing Switch Command Reference
addpnport
#Total:
0
0
#Conns
0
0
0
0
0
0
0
0
0
6-13