Switchcc - Cisco MGX 8850 Command Reference Manual

switchcc

switchcc
Switch Core Cards
Switch control of the node from the active PXM45 to the standby PXM45. If a standby PXM45 is not
available, the switchcc command fails.
You cannot execute switchcc during a configuration-copy. If you attempt it, the system blocks the
command. Furthermore, the command fails if the switch is unstable or if the standby PXM45 is not in
the standby state.
Cards on Which This Command Runs
PXM45
Syntax
switchcc
Related Commands
None
Attributes
Log: no log
Example
Attempt a switchcc without a standby PXM45 in the backplane.
raviraj.7.PXM.a >
Do you want to proceed (Yes/No)? y
Core card redundancy unavailable
raviraj.7.PXM.a >
Cisco MGX 8850 Routing Switch Command Reference
9-152
State: active
switchcc
Chapter 9
Privilege: SERVICE_GP
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Troubleshooting Commands