Cisco MGX 8850 Command Reference Manual page 543

Chapter 7 SPVC and SVC Commands
Traffic parameters such as CDV, CTD are entered at both the master and slave endpoints for both the
forward and reverse directions. However, the values of these parameters entered at the slave end are
ignored during call setup. Therefore, you can specify the lcdv, rcdv, lctd and rctd options at the master
end only.
SCT Default Traffic Parameters
The Service Class Templates (SCTs) provide the default traffic parameters for the logical ports. The
default traffic parameters are set to a fraction of the bandwidth available on the logical port. The SCT
ID (sctID) and interface type (ifType) parameters that are specified using the addport command
determine which default traffic parameters are used.
Note The default values of the SCTs cannot be changed using the Cisco WAN Manager (CWM).
Table 7-5
VSI-SIG
CBR.1
VBR-RT.1
VBR-RT.2
VBR-RT.3
VBR-nRT.1
VBR-nRT.2
VBR-nRT.3
UBR.1
UBR.2
ABR
CBR.2
CBR.3
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Default Traffic Parameters for AXSM
PCR SCR MCR
N/P N/P N/P
50 N/A N/A
50 50 N/A
50 50 N/A
50 50 N/A
50 50 N/A
50 50 N/A
50 50 N/A
50 N/A N/A
50 N/A N/A
50 N/A 50
50 N/A N/A
50 N/A N/A
ICR MBS MFS
N/P N/P N/U
N/A dspmbsdft N/U
N/A dspmbsdft N/U
N/A dspmbsdft N/U
N/A dspmbsdft N/U
N/A dspmbsdft N/U
N/A dspmbsdft N/U
N/A dspmbsdft N/U
N/A dspmbsdft N/U
N/A dspmbsdft N/U
50 dspmbsdft N/U
N/A dspmbsdft N/U
N/A dspmbsdft N/U
Cisco MGX 8850 Routing Switch Command Reference
addcon
CDVT
N/P
dspcdvtdft
dspcdvtdft
dspcdvtdft
dspcdvtdft
dspcdvtdft
dspcdvtdft
dspcdvtdft
dspcdvtdft
dspcdvtdft
dspcdvtdft
dspcdvtdft
dspcdvtdft
7-7