Cisco MGX 8850 Command Reference Manual page 325

Chapter 5 PNNI Commands
Figure 5-6
hierarchy
Bytes
Usage Guidelines
All MGX 8850 cards ship with default addresses. These defaults are provided for evaluation of the
switch. Before or while you deploy a switch, you should change the default addresses by executing either
cnfpnni-node or addpnni-node. The Cisco MGX 8850 Routing Switch Software Configuration Guide
explains node addressing in the section Guidelines for Creating an Address Plan.
The ATM address, address prefixes, and peer group ID share some default field values, as shown in
Figure
Related Commands
addpnni-node, delpnni-node, dsppnni-node, addaddr
Attributes
Log: log
Example
This example shows the cnfpnni-node command line that specifies the PNNI configuration values for a
node that already exists on the network. The command line configures the PNNI node as follows:
•
•
•
•
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Cisco Factory-shipped Defaults for PNNI Peer Group Identifier, PNNI Summary Address,
ATM Address, and PNNI Node Identifier
ATM
address
ATM
format
address
Cisco
length
ICD
PNNI
56 160 47 00 91 81 00 00 00 XX XX XX XX XX XX XX XX XX XX XX XX 00
level
# of
1 1 1 2
Default PNNI
peer group identifier
5-6.
State: active
The PNNI hierarchy level is 56.
The node ATM address is 47.0091 8100000000309409f1f1.00309409f1f1.01.
The node PNNI identifier is 56:160:47.00918100000000309409f1f1.00309409f1f1.01.
The node PNNI group identifier is 56:47.009181.0000.00. The length specified by the hierarchy
level is 56 (8 bytes) the following 12 zeros are fill.
MAC address
1 3 6
Default PNNI
summary address
Default ATM address
Default PNNI
node identifier
Privilege: SUPER_GP
Cisco MGX 8850 Routing Switch Command Reference
cnfpnni-node
MAC address
6 1
5-31