Cisco MGX 8850 Command Reference Manual page 591

Chapter 7 SPVC and SVC Commands
Incoming Call Failures
Incoming Call
Filtering Failures
Incoming Routing Failures
Incoming CAC Failures
Incoming Timer Failures
Incoming Crankback Failures
Outgoing Call Attempts
Outgoing Call Success
Outgoing Call Failures
Outgoing Call
Filtering Failures
Outgoing Routing Failures
Outgoing CAC Failures
Outgoing Timer Failures
Outgoing Crankback Failures
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Number of incoming point-to-point and point-to-multipoint
SVC/SPVC call attempts that failed on this port.
Number of incoming point-to-point and point-to-multipoint
SVC/SPVC call attempts that failed the address filtering on this
port.
Number of incoming point-to-point and point-to-multipoint
SVC/SPVC call attempts that failed on this port because there was
no route to the destination.
Number of incoming point-to-point and point-to-multipoint
SVC/SPVC call attempts that failed on this port because there were
not enough resources as requested in the traffic parameters of the
call.
Number of signaling timers that timed out on incoming
point-to-point and point-to-multipoint SVC/SPVC calls recieved on
this port.
Number of crankback IEs recieved on this port for incoming
point-to-point and point-to-multipoint SVC/SPVC call attempts.
Number of outgoing signalling messages—Setup and
AddParty—sent from this port for call establishment.
Number of outgoing signaling messages—Connect and
AddPartAck—sent from this port, which indicate successful call
establishment.
Number of outgoing point-to-point and point-to-multipoint
SVC/SPVC call attempts that failed on this port.
Number of outgoing point-to-point and point-to-multipoint
SVC/SPVC call attempts that failed the address filtering on this
port.
Number of outgoing point-to-point and point-to-multipoint
SVC/SPVC call attempts that failed on this port because there was
no route to the destination.
Number of outgoing point-to-point and point-to-multipoint
SVC/SPVC call attempts that failed on this port because there was
not enough resources as requested in the traffic parameters of the
call.
Number of signaling timers that timed out on outgoing
point-to-point SVC/SPVC calls sent from this port.
Number of crankback IEs sent from this port for outgoing signaling
release messages.
Cisco MGX 8850 Routing Switch Command Reference
dsppnconstats
7-55