Bootchange - Cisco MGX 8850 Command Reference Manual

bootChange

bootChange
Boot Change
Sets the boot IP address and gateway address of the PXM45 card. The boot IP address is used only when
the PXM45 card boots up.
In the current release, the only parameters you should enter are "inet on ethernet (e)" and "gateway inet
(g)." The bootChange command presents one parameter at a time. Therefore, press the Return (or Enter)
key at each prompt except for these two. The example in this description shows the two fields where you
need to enter an IP address and the fields you skip.
The boot IP address does not get saved with saveallcnf.
Note
Note Use the ipifconfig command to assign IP addresses for the PXM45 and the shelf.
Cards on Which This Command Runs
PXM45
Syntax
bootChange
Related Commands
none
Attributes
Log: log
Cisco MGX 8850 Routing Switch Command Reference
2-12
State: active Privilege: SERVICE_GP
Chapter 2 Shelf Management Commands
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001