Cisco MGX 8850 Command Reference Manual page 506

dsppnport
Example
First determine if connections exist on port 3:1.1:1 by executing dspcons. One connection exists, and
the display shows the view from each port (3:1.1:1 and 2:2.2:1). Display port 2:2.2:1 then port 3:1.1:1.
Note the differences in the display when you specify the master-end port and the slave-end port. Also,
note that the interface type is UNI 3.1.
The dsppnport display shows a combination of user-configured and dynamic details, as follows:
•
•
•
8850_NY.7.PXM.a > dspcons
Local Port
----------------------------+-----------------------------+-------+------
2:2.2:1
Local
Remote Addr: 47.00918100000000036b5e30cd.000001031801.00
3:1.1:1
Local
Remote Addr: 47.00918100000000036b5e30cd.000001021801.00
8850_NY.7.PXM.a > dsppnport 2:2.2:1
Port:
IF status:
8850_NY.7.PXM.a > dsppnport 3:1.1:1
Port:
IF status:
UCSM:
Auto-config:
IF-side:
UniType:
PassAlongCapab:
Input filter:
minSvccVpi:
minSvccVci:
minSvpcVpi:
p2p :
p2mp:
p2p :
p2mp:
8850_NY.7.PXM.a >
Cisco MGX 8850 Routing Switch Command Reference
6-88
Configuration details such as the type and version of the interface (UNI 3.1, for example), minimum
and maximum VPIs for SPVCs, and minimum and maximum VPIs and VCIs for SVCs.
A system-generated logical number that maps to the physical portID. The label these fields is
"Logical ID" and "Port," respectively. The values in this example are 16979969 for logical ID and
3:1.1:1 for port. Some PNNI commands require you to provide the logical ID, and dsppnport is one
command that can provide it.
Dynamic information such as:
– Status of the port
The number of point-to-point and point-to-multipoint connections
–
The numbers of configured and active of SPVCs and SVCs
–
Vpi.Vci
10 100
Addr: 47.00918100000000036b5e30cd.000001021801.00
10 100
Addr: 47.00918100000000036b5e30cd.000001031801.00
2:2.2:1
provisioning
3:1.1:1
up
enable
enable
network
private
n/a
0
0
35
1
#SpvcCfg: #SpvcActive:
1 0
0 0
#Svcc: #Svpc:
0 0
0 0
Chapter 6
Remote Port Vpi.Vci
3:1.1:1 10 100
2:2.2:1 10 100
Logical ID:
Admin Status:
Logical ID:
Admin Status:
Addrs-reg:
IF-type:
Version:
Output filter:
maxSvccVpi:
maxSvccVci:
maxSvpcVpi:
#SpvpCfg: #SpvpActive:
0 0
0 0
Total:
0
0
Total: 0
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Logical Node, Port, and Signaling Commands
State Owner
FAIL MASTER
FAIL SLAVE
n/a
up
16979969
up
enable
uni
uni3.1
0
4095
65535
4095