Cisco MGX 8850 Command Reference Manual page 413

Chapter 5 PNNI Commands
dsppnni-svcc-rcc-timer
Display PNNI Switched Virtual Connection Routing Control Channel (SVCC-RCC) Timer Values
SVCC-based RCC timer values.
The dsppnni-svcc-rcc-timer command displays the SVCC-RCC timer values that are set by the
cnfpnni-svcc-rcc-timer command.
Note This command applies to multi-peer groups only.
If you specify node-index, the command displays the SVCC-based Routing Control Channel (RCC)
timer values of the node-index PNNI node.
Cards on Which This Command Runs
PXM45
Syntax
dsppnni-svcc-rcc-timer
[node-index]
Syntax Description
node-index
Display Contents
The following parameters are displayed for each node.
node-index
Init time
Retry time
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Specify the node identifier in the range 1–10. In the current release, the value of
the node-index variable must be '1'.
Range: 1–10
Default: 1
The local node identifier within the hierarchy. The range is 1–10. In the current
release, the value of node-index is '1'.
Range: 1–10
Display the value of -initTime—the interval (in sec) that this node delays
advertising its choice of a preferred SVCC to a neighbor with a numerically lower
ATM address, The interval begins when the SVCC is established.
Range: 1–10
Displays the interval (in sec) this node will delay after an apparently necessary and
viable SVCC-based RCC is unexpectedly torn down, before attempting to
re-establish it.
Range: 10–60
Cisco MGX 8850 Routing Switch Command Reference
dsppnni-svcc-rcc-timer
— display the PNNI
5-119