Cnfrscprtn - Cisco MGX 8850 Command Reference Manual

cnfrscprtn

cnfrscprtn
Configure Resource Partition
Modifies a resource partition. A resource partition on an AXSM consists of minimum and maximum
percentages of bandwidth, a VPI/VCI range, and a minimum and maximum number of connections
available to a network control application. The current network controller is PNNI. Refer to the
description of addrscprtn for information on resource partitions.
The cnfpart and cnfrscprtn commands are identical. The name 'cnfrscprtn' is consistent with the
Note
corresponding command in Release 1 of the MGX 8850 switch. You can use either command.
Cards on Which This Command Runs
AXSM
Syntax
cnfrscprtn
-if <if>
-id <partionID>
-ctlr <controllerID>
-emin <egrMinBw>
-emax <egrMaxBw>
-imin <ingMinBw>
-imax <ingMaxBw>
-vpmin <minVpi>
-vpmax <maxVpi>
-vcmin <minVci>
-vcmax <maxVci>
-mincon <min connections>
-maxcon <max connections>
The maximum number of connections must be greater than 10.
Note
Syntax Description
Note On a virtual trunk, the min_vpi and max_vpi must be the same.
-if
-id
-ctlr
-emin
Cisco MGX 8850 Routing Switch Command Reference
3-36
Logical interface (port) number. For AXSM, the range is 1–60.
This parameter is the same as the ifNum appearing in other commands.
The number of the partition in the range 1–5.
The number of the controller in the range 1–20.
A guaranteed percentage of egress bandwidth. Each unit of egrMinBw is 0.00001 of
the total bandwidth on the port. (An egrMinBw of 1000000 = 100%.) This approach
provides a high level of granularity.
Chapter 3 Equipment and Resource Provisioning
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001