Dsppnni-Reachable-Addr - Cisco MGX 8850 Command Reference Manual

Chapter 5 PNNI Commands
Display Contents for dsppnni-reachable-addr
The table contains all reachable addresses within a peer group comes from the internal data base (IDB).
scope
port id
Exterior
ATM addr prefix
node name
Advertising node
number
Transit Network ID
Related Commands
dsppnni-link
Attributes
Log: nolog
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Note The UNI 4.0 address scope. Refer to ATM forum documentation for
a description of these scopes. The current release does not support
UNI 4.0, so scope currently is always '0'.
Range
The logical port identifier.
The flag that indicates whether the node is an interior or exterior node.
true: the node is an exterior node.
false: the node is an interior node.
The PNNI summary address assigned to the node.
The name of the switch results from the cnfname command and appears in the
CLI prompt.
The number of the remote node that has advertised information to the current
node. This number has a range of 1–256 and appears only if you specified the
network argument.
The local node generates the node numbers in the sequence that it discovers its
neighbors. You can only provide it as a command parameter or view it in
applicable displays. (Note that this node index or node number is not the node
index that identifies a node within the hierarchy of a multiple-peer group. See
dsppnni-node for details on the local node index.)
The transit network ID identifies a network where connections from the current
node do not terminate.This number applies to static addresses only. The
application of this option depends on the design intent of the user. The ID can
have up to four IA5 characters (IA5 is a superset of the ASCII character set).
State: active, standby Privilege: ANYUSER
Cisco MGX 8850 Routing Switch Command Reference

dsppnni-reachable-addr

5-105