Cisco MGX 8850 Command Reference Manual page 402

dsppnni-routing-policy
dsppnni-routing-policy
Display PNNI Routing Policy
The dsppnni-routing-policy command displays the parameters associated with the current routing
policy for this node. The displayed parameters determine:
•
•
•
•
•
Caution You can change the routing policies to optimize PNNI routing for your network, but incorrect routing
policies can cripple or even crash a network. You should not change routing policies on a live
network. Use this command only after careful planning.
Cards on Which This Command Runs
PXM45
Syntax
dsppnni-routing-policy
Cisco MGX 8850 Routing Switch Command Reference
5-108
— display the PNNI routing policy parameters.
The tolerance of cost-calculations.
The frequency of routing table generation.
The type of load balancing that is specified.
The type of on-demand routing that is specified.
The type of administration weight table that is enabled.
Chapter 5
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
PNNI Commands