Dspln - Cisco MGX 8850 Command Reference Manual

Chapter 9 Troubleshooting Commands

dspln

Display Line
Display the configuration of a physical line.
Note The connection count includes control VCs when you execute dspln on the CLI of a service module.
However, when you execute dspcd or dsppnport(s) on the CLI of the controller card, the display
does not include control VCs.
Cards on Which This Command Runs
AXSM
Syntax
dspln
<-ds3 | -sonet> <bay.line>
Syntax Description
-ds3
-sonet
bay.line
Related Commands
upln, cnfln, delln
Attributes
Log: no log
Examples
Display T3 line 1 on the current AXSM.
pinnacle.2.AXSM.a > dspln -ds3 1.2
LineNum:
LineEnable:
LineType:
LineCoding:
LineLength(meters):
LineOOFCriteria:
LineAIScBitsCheck:
LineLoopback:
Xmt. Clock source:
LineRcvFEACValidation: 4 out of 5 FEAC codes
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Command delineator that precedes the line number entry for a T3 of E3 line.
Command delineator that precedes the line number entry for a SONET line.
Identifies the bay (1 or 2) and the number of the line. The line number can be 1 to the
highest numbered line on the back card.
State: active, standby
1.2
Down
ds3cbitadm
ds3B3ZS
0
fBits3Of8
Check
NoLoop
localTiming
Privilege: ANYUSER
Cisco MGX 8850 Routing Switch Command Reference
dspln
9-111