Dbgilmi - Cisco MGX 8850 Command Reference Manual

dbgilmi

dbgilmi
Debug ILMI
Use dbgilmi to debug ILMI functionality (such as address registration or auto configuration).
Note VSI pass-through information is exchanged between only the controller (PNNI) and the switch.
Cards on Which This Command Runs
PXM45
Syntax
dbgilmi {enable | disable}[<portid>]
[-log <vsi | func | minor | major | warning | error | dump | fatal | all>]
[-dbg <vsi | func | minor | major | warning | error | dump | fatal | all>]
Syntax Description
enable | disable
portid
-log
-dbg
Attributes
Log: log
Cisco MGX 8850 Routing Switch Command Reference
4-14
Activate or de-activate debugging.dbgilmi.
The portid is the PNNI physical port. The format is
[shelf.]slot[:subslot].port[:subport]. See also
vsi
func
minor
major
warning
error
dump
fatal
all: log all
vsi
func
minor
major
warning
error
dump
fatal
all: dbg all
State: active, standby
PNNI Format, page
Privilege: SERVICE_GP
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 4 ILMI Commands
4-2.