Dsppnportsig - Cisco MGX 8850 Command Reference Manual

Chapter 6 Logical Node, Port, and Signaling Commands

dsppnportsig

Display Port Signaling—displays signaling parameters on a port.
The dsppnportsig command displays the ATM signaling parameters as configured by cnfpnportsig.
Cards on Which This Command Runs
PXM45
Syntax
dsppnportsig <portid>
Syntax Description
portid
Related Commands
cnfpnportsig
Attributes
Log: log
Examples
Display signaling for port 3:1.1:1 then port 2:2.2:1. Note the interface type for 3:1.1:1 is UNI, and the
UNI version is 3.1. On port 2:2.2:1, the interface type is NNI, and the version is IISP 3.1.
8850_NY.8.PXM.a > dsppnportsig 3:1.1:1
provisioned IF-type: uni
sigType:
addrPlan:
VpiVciAllocator:
PassAlongCapab:
sigVpi:
rccVpi:
8850_NY.8.PXM.a > dsppnportsig 2:2.2:1
provisioned IF-type: nni
sigType:
addrPlan:
VpiVciAllocator:
PassAlongCapab:
sigVpi:
rccVpi:
8850_NY.8.PXM.a >
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
See PNNI Format, page 6-4. The portid represents the PNNI physical port and has the
format [shelf.]slot[:subslot].port[:subport].
State: active, standby
version:
private side:
aesa
n/a HopCounterGen:
n/a
0 sigVci:
n/a rccVci:
version:
private side:
aesa
n/a HopCounterGen:
enable
0 sigVci:
n/a rccVci:
Privilege: ANYUSER
uni3.1
network
n/a
5
n/a
iisp31
network
n/a
5
n/a
Cisco MGX 8850 Routing Switch Command Reference
dsppnportsig
6-99